Trade
Drywall, Taping and Steel Stud Framing
Framing through to paint-ready surfaces, for homeowners, builders and general contractors across Saskatoon.
Overview
The finish is only as good as the frame behind it
A wall that is out of square or out of plane cannot be corrected with joint compound. Getting the framing right is what makes a flat, clean finish achievable at all.
We handle both wood and steel stud framing and take the work through board, tape, sand and texture, direct for owners, or as a subcontract package for other contractors.
What this solves
- 01A finish is showing joints, waves or nail pops
- 02A basement or commercial shell needs framing through to paint-ready
- 03A builder needs a reliable drywall crew that turns up
Scope
What is included
Wood and steel stud framing
New construction, basement development, renovation and commercial partitions, squared, level and set out for a flat finish.
Drywall installation
Measured, cut and fixed to minimise seams, on walls and ceilings.
Mudding and taping
Joints taped, multiple coats applied and sanded to a paint-ready finish.
Ceiling texture
Spantex and similar textured ceiling finishes, applied consistently across the area.
Repair and patching
Holes, cracks, dents and water damage made good and blended into surrounding surfaces.
Basement finishing
Framing through to finished, taped and textured surfaces below grade.
Process
How the work runs
01
Measure and quote
We look at the area, the access and the required finish level, then price it in writing.
02
Framing
Wood or steel stud framing, squared and set out.
03
Board and tape
Board fixed, joints taped, coats applied and sanded.
04
Texture and handover
Texture where specified, then inspection under working light before handover.
Questions
Common questions
Yes. Framing and drywall packages for general contractors and builders are a regular part of our work. Talk to us about scheduling and scope.
Tell us what the space needs. A ceiling under raking light and a storeroom wall do not require the same preparation, and pricing should reflect that rather than assuming one standard.
Usually a close match is achievable. An exact match on an older texture is not always possible, and we will tell you before starting rather than after.
Both. Steel stud is standard on most commercial partitions; wood remains common in residential work.
Part of our trade services work
See the full range, or tell us what you are planning and we will point you to the right starting point.
Next step
Start your project with a written estimate.
Tell us what you are planning. We visit the site, agree the scope, and put an itemised price in writing.